Managing SIP connections

SIP Connection management lets you manage the SIP Connection between your service and the SBC device including:

■ Create SIP connections between your managed service and the SBC device (seeAdd SIP connections - Essentials Plus and Pro ).
■ Load DIDs to your managed service (see Load DIDs to managed service).
■ Import a file containing a list of IP-PBX users to your managed service (see Import IP-PBX users).
■ Upload Dial plan to SBC device (see Upload Dial plan to SBC).
➢ To manage SIP Connections:
1. In the Service portal Navigation pane, select Configuration > SIP Connections.

The table below describes the parameters in this page.

Parameter

Description

SIP Connection

The name of the SIP Connection representing the PSTN gateway and SBC configuration used to route calls for the site location; configured in the Onboarding wizard for the initial connection and in the Upgrade wizard for additional connections (see Configure SBC for Hosted Essentials Plus service or Configure SBC for Hosted Pro service).

The name of the initial SIP Connection (created when the service is onboarded) is always derived from the name of the service and cannot be changed; do not remove this connection. When adding new SIP Connections, you can define any name.

SBC

Name of the Service Provider SBC device or the BYOC device attached to the SIP Connection.

Deployment Status

Indicates the SIP Connection is configured on the SBC device.

Actions

■ Manage SBC Prefixes
■ Import PBX Users