Notice

Information contained in this document is believed to be accurate and reliable at the time of printing. However, due to ongoing product improvements and revisions, AudioCodes cannot guarantee accuracy of printed material after the Date Published nor can it accept responsibility for errors or omissions. Updates to this document can be downloaded from https://www.audiocodes.com/library/technical-documents.

This document is subject to change without notice.

Date Published: September-18-2024

WEEE EU Directive

Pursuant to the WEEE EU Directive, electronic and electrical waste must not be disposed of with unsorted waste. Please contact your local recycling authority for disposal of this product.

Security Vulnerabilities

All security vulnerabilities should be reported to vulnerability@audiocodes.com.

Customer Support

Customer technical support and services are provided by AudioCodes or by an authorized AudioCodes Service Partner. For more information on how to buy technical support for AudioCodes products and for contact information, please visit our website at https://www.audiocodes.com/services-support/maintenance-and-support.

Documentation Feedback

AudioCodes continually strives to produce high quality documentation. If you have any comments (suggestions or errors) regarding this document, please fill out the Documentation Feedback form on our website at https://online.audiocodes.com/documentation-feedback.

Stay in the Loop with AudioCodes

Notes and Warnings

Read and adhere to all warning statements in this document before installing the device.

The device is an INDOOR unit and must be installed only indoors.

(French) Avertissement: L’appareil est une unité d’INTERIEUR et doit donc obligatoirement être installé en intérieur.

Ethernet port interface cabling must be routed only indoors and must not exit the building.

(French) Avertissement: Le câblage de l’interface du port Ethernet doit être acheminé uniquement en intérieur et ne doit pas sortir du bâtiment.

FXS indoor module: FXS port interface cabling must be routed only indoors and must not exit the building.

(French) Avertissement: FXS module intérieur: le câblage de l’interface du port FXS doit être acheminé uniquement en intérieur et ne doit pas sortir du bâtiment.

The device is supplied as a sealed unit and must be installed and serviced only by qualified service personnel.

(French) Avertissement: L’appareil doit obligatoirement être installé et entretenu par un agent de service qualifié.

Disconnect the device from the mains and Energy Source (ES) before servicing.

(French) Avertissement: Débranchez l’appareil du secteur et de la Energy Source (ES) avant toute réparation.

Caution Electrical Shock: Do not open or disassemble this device. The device carries high voltage and contact with internal components may expose you to electrical shock and bodily harm.

(French) Attention életrocution: Ne tentez pas d’ouvrir ni de démonter l’appareil. L’appareil transporte une haute tension et son contact avec des composants internes risque de vous exposer à l’électrocution et à des lésions corporelles.

Open source software may have been added and/or amended for this product. For more information, contact your AudioCodes sales representative.

Regulatory Information

VoIP Gateway

This equipment complies with Part 68 of the FCC Rules and the requirements adopted by the ACTA. On the bottom of the unit or on the Interface card of this equipment is a label that contains among other information, a product identifier in the format US:AC1IS00BM1KMIX or US:AC1ISNANM1000 and ringer equivalence. If requested, this number must be provided to the telephone company.

This equipment is designed to be connected to the telephone network using an RJ-48C and/or RJ-11C connector, which is Part 68 compliant. The service order codes (SOC) are 6.0F for digital interfaces and 9.0Y for analog interfaces and the Facility interface codes (FIC) are: 04DU9.1SN, 04DU9.1KN, 04DU9.BN, 04DU9.DN, 02LS2, O2GS2.

For FXO Only: The REN is used to determine the number of devices that may be connected to a telephone line. Excessive RENs on a telephone line may result in the devices not ringing in response to an incoming call. In most but not all areas, the sum of RENs should not exceed five (5.0). To be certain of the number of devices that may be connected to a line, as determined by the total RENs, contact the local telephone company. The REN for this product is 0.5.

Should the product cause harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of service may be required. If advance notice is not practical, you will be notified as soon as possible. In addition, you will be advised of your right to file a complaint with the FCC if it is necessary.

The telephone company may make changes in its facilities, equipment, operations or procedures that could affect the operation of the equipment. If this happens, the telephone company will provide advance notice in order for you to make necessary modifications to maintain uninterrupted service.

If trouble is experienced with this equipment, for repair or warranty information please contact AudioCodes Inc. 200 Cottontail Lane, Suite A101E, Somerset NJ 08873, USA; Tel: +1-732-469-0880, Fax: +1-732-469-2298. If the equipment is causing harm to the telephone network, the telephone company may request to disconnect the equipment until the problem is resolved.

Connection to Telephone Company Provided coin service is prohibited. Connection to party lines service is subject to state tariffs.

Document Name
Mediant 1000 Datasheet
SBC-Gateway Series Release Notes
Mediant 1000B Gateway & E-SBC SIP User's Manual

Document Revision Record

LTRT	Description
41414	New warning bulletin regarding plastic sticker covering spare AC power socket; New section for replacing Power Supply module; new drawings for replacing modules.
41415	Installing operating system (OS) on OSN was modified (OS is not installed by default).
41417	FXO warning statement added.
41418	Hardware Maintenance chapter was updated (rear-panel slot assignment section added; front-panel module replacement updated; OSN server module replacement updated).
41420	Correction to SWX module port labels; chassis weight.
41422	Fan Tray module replacement procedure added.
41424	MPM module slot assignment; BRI/PRI Fallback section updated.
41426	RS-232 cable adapter ordering information modified.
41427	Power surge protection warnings.
41430	HDMI connector.
41431	Power Supply module replacement update; physical dimensions; miscellaneous formatting.
41432	Module slot assignment update.
41433	FXS outdoor module added and relevant cabling instructions (for power surge protection); OSN 3/4 reset button described; HDMX module LED description typo; AC power cable note added (Japanese).
41434	REN for FXO.
41435	FXS outdoor limitation for simultaneous ring and off-hook long haul.
41436	FXS outdoor-routing warning bulletin updated.
41437	Ethernet port 0/3 added to CRMX.
41438	Dry-contact relay interface added.
41439	FXS module part numbers updated.
41441	Logo updated; fallback updated.
41443	OSN3C and OSN4B modules added; HDMI cable connector updated with figure; FXS module for indoor-and-outdoor updated.
41444	Duration of press for reset to defaults; trademarks.
41445	New CRMX module; regulations updated; only OSN4B kept in document.
41446	Replacing CRMX module and faulty device.
41447	EN 55024 updated to EN 55035.