Notice

Information contained in this document is believed to be accurate and reliable at the time of printing. However, due to ongoing product improvements and revisions, AudioCodes cannot guarantee accuracy of printed material after the Date Published nor can it accept responsibility for errors or omissions. Updates to this document can be downloaded from https://www.audiocodes.com/library/technical-documents.

This document is subject to change without notice.

Date Published: November-10-2024

WEEE EU Directive

Pursuant to the WEEE EU Directive, electronic and electrical waste must not be disposed of with unsorted waste. Please contact your local recycling authority for disposal of this product.

Security Vulnerabilities

All security vulnerabilities should be reported to vulnerability@audiocodes.com.

Customer Support

Customer technical support and services are provided by AudioCodes or by an authorized AudioCodes Service Partner. For more information on how to buy technical support for AudioCodes products and for contact information, please visit our website at https://www.audiocodes.com/services-support/maintenance-and-support.

Documentation Feedback

AudioCodes continually strives to produce high quality documentation. If you have any comments (suggestions or errors) regarding this document, please fill out the Documentation Feedback form on our website at https://online.audiocodes.com/documentation-feedback.

Stay in the Loop with AudioCodes

Twitter Facebook LinkedIn YouTube Blog

Notes and Warnings

The device is an INDOOR unit and thus, must be installed ONLY indoors.  In addition, Ethernet port interface cabling     must be routed only indoors and must not exit the building.

Avertissement: L’appareil est une unité d’INTERIEUR et doit donc obligatoirement être installé en intérieur. En outre, le câblage de l’interface du port Ethernet doit être acheminé uniquement en intérieur et ne doit pas sortir du bâtiment.

Installation of this device must be in a weather protected location of maximum ambient temperature of 40°C.

Avertissement: L’installation de cet appareil doit avoir lieu dans un local protégé des intempéries de     température ambiante maximale de 40°C.

Installation and service of this device must be made only by qualified service personnel in restricted access locations and connected to an earthed power socket.

Avertissement: L’entretien de maintenance de cet appareil doit être effectué uniquement par un personnel de service qualifié dans des locaux à accès limité et l’appareil étant branché à une prise mise à la masse.

Caution Electrical Shock

Do not attempt to open or disassemble this device. The device carries high voltage. Contact with internal components may cause electrical shock and bodily harm.

Attention életrocution

Ne tentez pas d’ouvrir ni de démonter l’appareil. L’appareil transporte une haute tension et son contact avec des composants internes risque de vous exposer à l’électrocution et à des lésions corporelles

This device is intended to accommodate only AMC modules approved by AudioCodes.

Avertissement: Cet appareil est destiné à recevoir uniquement des modules AMC approuvés par AudioCodes.

Modules may contain a non-rechargeable lithium battery. If you need to replace the battery, replace it only with batteries of the same type and manufacturer.

Avertissement: Les modules peuvent contenir une batterie lithium non-rechargeable. Si vous devez remplacer la batterie, remplacez-la uniquement par des batteries du même type et du même fabricant.

Related Documentation

Document Name

Datasheet

Mediant 2600 SBC User's Manual

Document Revision Record

LTRT

Description

41576

Initial versions.

41577

AC power cable warning (Japanese).

41578

Logo updated.

41579

19-inch rack mounting brackets updated.

42120

Fan tray and Power Supply modules replacement updated.

42121

Duration of press for reset to default; trademarks.

42122

Min. operating temp.

42123

Duration of press for reset.

42124

19-inch mounting brackets (front supplied unattached and rear can be ordered)

42126

LEDs for HA state updated.