Configuring the Answer Detector Feature
The device's Answer Detect (AD) feature detects voice activity in a call. The AD feature detects the following events:
|
■
|
Speech - speech is detected. |
|
■
|
End of speech - silence (no speech) for the configured duration (see below) is detected. |
|
1.
|
Open the DSP Settings page (Setup menu > Signaling & Media tab > Media folder > DSP Settings). |
|
2.
|
Scroll down to the Answer Detector group: |
|
3.
|
Select the 'Enable Answer Detector' check box to enable the feature. |
|
4.
|
In the 'Answer Detector Activity Delay' field, enter the time (in 100-msec resolution) between when the device activates the Answer Detector feature and when it actually starts to detect. This delay may increase the device’s immunity to noises and non-speech signals at the beginning of a conversation. |
|
5.
|
In the 'Answer Detector Silence Time' field, enter the silence duration from when no speech input is detected until the device reports an End Of Speech event. |
|
6.
|
From the 'Answer Detector Redirection' drop-down list, select if the Answer Detector is applied to the IP network side (Yes) instead of the PSTN side (No). |
|
7.
|
In the 'Answer Detector Sensitivity' field, enter the Answer Detector's sensitivity, where 0 is the highest and 7 the lowest. |