Configuring Allowed Firewall Rules for Media Transcoding Cluster
If you have configured the device with any firewall rules in the Firewall table (see Configuring Firewall Rules), it is recommended that the below firewall rules be configured to allow connectivity with the Media Components.
Allow Firewall Rules for Media Transcoding Cluster
|
Index |
Source IP |
Source Port |
Prefix Length |
Start Port |
End Port |
Protocol |
Use Specific Interface |
Interface Name |
Action Upon Match |
Packet Size |
Byte Rate |
Byte Burst |
|---|---|---|---|---|---|---|---|---|---|---|---|---|
| 0 |
Various rules for basic traffic |
|||||||||||
| ... | ||||||||||||
| 3 | ||||||||||||
| 4 |
0.0.0.0 |
2424 |
32 |
0 |
65535 |
tcp |
Enable |
CLUSTER_IF |
Allow |
0 |
0 |
0 |
| 5 |
0.0.0.0 |
0 |
32 |
3900 |
3900 |
udp |
Enable |
CLUSTER_IF |
Allow |
0 |
0 |
0 |
|
6 |
0.0.0.0 |
0 |
32 |
6000* |
6000 |
udp |
Enable |
CLUSTER_IF |
Allow |
0 |
0 |
0 |
| 7 |
0.0.0.0 |
0 |
0 |
0 |
65535 |
Any |
Disable |
-- |
Block |
0 |
0 |
0 |
* 6000 is the default UDP port as defined by the 'RTP Base UDP Port' [BaseUDPport] parameter. If you modify this parameter, then you need to change the firewall rules accordingly.
If the device needs to communicate with