Configuring SNMP Community String for Traps
You can configure a unique password-like community string for sending SNMP traps. The device sends the traps with the configured community string.
|
➢
|
To configure SNMP community strings for traps: |
|
1.
|
Open the SNMP Settings page (Setup menu > Administration tab > SNMP folder > SNMP Settings). |
|
2.
|
In the 'Trap Community String' field, configure a community string: |
|
3.
|
Click Apply, and then reset the device with a save-to-flash for your settings to take effect. |
The community string can be up to 30 characters and can include only the following:
|
●
|
Upper- and lower-case letters (a to z, and A to Z) |
The default is "trapuser".
The parameter cannot be configured with wide characters.