General Parameters
The general debugging and diagnostic parameters are described in the table below.
General Debugging and Diagnostic Parameters
|
Parameter |
Description |
||||||
|---|---|---|---|---|---|---|---|
|
enablesecsyslog [EnableSecSyslog] |
Enables the reporting of security-related events for the data-router networking. When enabled, the data-router access list rules, configured using the access-list CLI command, which are set to "log", send Syslog messages whenever traffic matching the access list is encountered.
|
||||||
|
'Delay After Reset [sec]' configure voip > sip-definition advanced-settings > delay-after-reset [GWAppDelayTime] |
Defines the time interval (in seconds) that the device's operation is delayed after a reset. The valid range is 0 to 45. The default is 7 seconds. Note: This feature helps overcome connection problems caused by some LAN routers or IP configuration parameters' modifications by a DHCP server. |
||||||
|
configure system > hw > usb-power [UsbPowerCtrl] |
Shuts down the USB port(s), by disconnecting power to them.
|
||||||
|
[EnableAutoRAITransmitBER] |
Enables the device to send a remote alarm indication (RAI) when the bit error rate (BER) is greater than 0.001.
|