bri
This command configures BRI interfaces.
Syntax
(config-voip)# interface bri <Slot (Module)/Port> (bri <Slot/Port>)#
|
Command |
Description |
|||||||||
|---|---|---|---|---|---|---|---|---|---|---|
|
b-channel-nego-for-trunk {any| exclusive| not-set | preferred} |
ISDN B-Channel negotiation mode for the trunk. |
|||||||||
|
call-re-rte-mode |
Call Rerouting Mode for Trunk. |
|||||||||
|
clock-priority |
Sets the trunk priority for auto-clock fallback. |
|||||||||
|
dig-oos-behavior |
Setting Digital OOS Behavior |
|||||||||
|
isdn-bits-cc-behavior |
Sets the ISDN Call Control Layer (Layer 4) behavior options. |
|||||||||
|
isdn-bits-incoming-calls-behavior |
Sets the ISDN incoming calls behavior options. |
|||||||||
|
isdn-bits-ns-behavior |
Sets the ISDN Network Layer (Layer 3) behavior options. |
|||||||||
|
isdn-bits-ns-extension-behavior |
Sets additional ISDN Network Layer (Layer 3) behavior options. |
|||||||||
|
isdn-bits-outgoing-calls-behavior |
Sets the ISDN outgoing calls behavior options. |
|||||||||
|
isdn-layer2-mode |
Sets the ISDN layer2 mode. |
|||||||||
|
isdn-termination-side |
Sets the ISDN termination side. |
|||||||||
|
isdn-xfer-cab |
Send transfer capability to ISDN side on setup message. |
|||||||||
|
local-isdn-rbt-src |
If the ringback tone source is not IP, who should supply the Ringback tone. |
|||||||||
|
ovrlp-rcving-type |
Select reception type of overlap dialing from ISDN side |
|||||||||
|
pi-in-rx-disc-msg |
Configure PIForDisconnectMsg to overwrite PI value received in ISDN Disconnect message |
|||||||||
|
pi-to-isdn |
Override the value of progress indicator to ISDN side in ALERT, PROGRESS, and PROCEEDING messages |
|||||||||
|
play-rbt-to-trk |
Enable ringback tone playing towards trunk side. |
|||||||||
|
port-info |
Defines a descriptive name for the port. |
|||||||||
|
protocol |
Sets the PSTN protocol to be used for this trunk. |
|||||||||
|
pstn-alrt-timeout |
Max time (in seconds) to wait for connect from PSTN |
|||||||||
|
rmv-calling-name |
Remove Calling Name For Trunk. |
|||||||||
|
tei-assign-trigger |
Bit-field defines when TEI assignment procedure is invoked |
|||||||||
|
tei-config-p2mp |
TEI value for P2MP BRI trunk. |
|||||||||
|
tei-config-p2p |
TEI value for P2P BRI trunk. |
|||||||||
|
tei-remove-trigger |
Bit-field defines when TEI should be removed. |
|||||||||
|
trace-level {full-isdn| full-isdn-with-duplications| layer3| layer3-no-duplications| no-trace| q921-raw-data| q931| q931-q921-raw-data| q931-raw-data} |
Defines the BRI trunk trace level. Note:
|
|||||||||
|
trk-xfer-mode-type |
Type of transfer the PSTN/PBX supports. |
Command Mode
Privileged User
Example
This example configures BRI to NI2 ISDN protocol type (51):
(config-voip)# interface bri 2/1 (bri 2/1)# protocol 51 (bri 2/1)# activate