settings

This command configures the Redirect Number IP-to-Tel table, which lets you define manipulation rules for manipulating the redirect number received in SIP messages for IP-to-Tel calls.

Syntax

(config-voip)# gateway manipulation settings 
(gw-manip-settings)# 

Command

Description

add-cic

If add carrier identification code as prefix.

add-ph-cntxt-as-pref

Adds the phone context to src/dest phone number as prefix.

add-prefix-for-isdn-hlc-fax

If set and incoming ISDN SETUP contains High Layer Compatability IE with Facsimile, prefix FAX will be added to received Calling number.

alt-map-tel-to-ip

Enables different number manipulation rules for redundant calls.

ip2tel-redir-reason

Set the IP-to-TEL Redirect Reason.

map-ip-to-pstn-refer-to

if set to 1, manipulate destination number from REFER-TO in TDM blind transfer.

prefix-2-ext-line

FXS: If enabled (1) and Prefix2ExtLine is detected, it is added to the dial number as prefix

prfm-ip-to-tel-dst-map

Perform Additional IP2TEL Destination Manipulation

prfm-ip-to-tel-src-map

Perform Additional IP2TEL Source Manipulation

swap-tel-to-ip-phone-num

Swaps calling and called numbers received from Tel side.

tel-to-ip-dflt-redir-rsn

Tel-to-IP Default Redirect Reason.

tel2ip-dst-nb-map-dial-index

Tel to IP Destination Number Mapping Dial Plan Index.

tel2ip-redir-reason

Tel-to-IP Redirect Reason.

tel2ip-src-nb-map-dial-index

Tel to IP Source Number Mapping Dial Plan Index.

tel2ip-src-nb-map-dial-mode

Tel to IP Source Number Mapping Dial Plan Mode.

use-refer-by-for-calling-num

If set to 1, use a number from Referred-By URI, as a calling number in outgoing Q.931 SETUP.

Command Mode

Privileged User