show voip interface
This command displays information (basic configuration, status and Performance Monitoring) of a specified telephony interface (E1/T1, BRI or FXS/FXO).
Syntax
show voip interface {e1-t1|bri|fxs-fxo} <Trunk ID|Module/Port>
|
Command |
Description |
|---|---|
|
e1-t1 |
Displays information on a specified E1/T1 interface. |
|
bri |
Displays information on a specified BRI interface. |
|
fxs-fxo |
Displays the current status, main PM parameters and main configuration parameters to a specific analog interface (FXS or FXO |
|
Trunk ID |
Defines the E1/T1 Trunk ID. Note: This is applicable only to |
|
Module |
Defines the module slot index as shown on the front panel. Note: This is not applicable to |
|
Port |
Defines the module's analog port number (FXS/FXO) or trunk port number (E1/T1 or BRI) to display. Note: This is not applicable only to |
Command Mode
Basic and Privileged User
Note
| ■ | Parameters displayed depend on the PSTN protocol type. |
| ■ | The command is applicable to devices supporting analog and/or digital PSTN interfaces. |
Example
Displaying information of the E1/T1 interface of trunk port 1 of trunk module 3:
show voip interface e1-t1 3/1 show voip interface e1-t1 3/1 ------------------------------- module/port: 3/1 trunk number: 0 protocol: t1_transparent state: not active alarm status: LOS 1, LOF 0, RAI 0, AIS 0, RAI_CRC 0 loopback status: no loop send alarm status: no alarm main performance monitoring counters collected in the last 470 seconds: BitError: 0 EBitErrorDetected: 0 CRCErrorReceived: 0 LineCodeViolation: 0 ControlledSlip: 0 ControlledSlipSeconds: 0 ErroredSeconds: 0 BurstyErroredSeconds: 0 UnAvailableSeconds: 470 PathCodingViolation: 0 LineErroredSeconds: 0 SeverelyErroredSeconds: 0 SeverelyErroredFramingSeconds: 0 basic configuration: framing: T1_FRAMING_ESF_CRC6 line-code: B8ZS clock-master: CLOCK_MASTER_OFF clock-priority: 0 trace-level: no-trace