Connecting the RS-232 Serial Interface
The device’s RS-232 interface port is used to access the CLI for serial communication.
|
■
|
Connector Type: 12-pin female LX40-12P Hirose connector. |
|
■
|
Connector Pinouts: Refer to pinouts shown in orderable RS-232 cable adaptor below. "P1" and "P2" are standard 9-pin DB for PC COM connectivity; "P3" is the Hirose male connector. |
For cabling, you can purchase an RS-232 cable adapter (9-pin DB to flat connector) from AudioCodes. You can either order a single cable adapter (only when ordering the Mediant 1000B) or a kit of 10 cable adapters (can be purchased any time).
Orderable RS-232 Cable Adapter
Orderable RS-232 cable adapter:
|
●
|
Conductive 30 (7/0.1)x6C, Tinned copper wire. PVC Coating dia=0.6mm, Color black. Shield: AL (MAYLER)+BRAID (16/4/0.12) Tinned copper wire, coverage 90% min. Filler cotton yarn. Assembly cotton paper. Jacket PU (4485AF), dia=4mm. |
|
●
|
Operation Temp: -10 c ->+80 c |
|
●
|
Insulation resistance: DC/100V 5M OHM MIN. |
|
●
|
Withstand Voltage: AC/250V 2mA, for one minute. |
|
●
|
UL Note: Cable components according to UL standard. |
|
➢
|
To connect the serial interface port to a computer: |
|
1.
|
Connect the flat connector (labeled "P3" in the previous figure) to the serial port (labeled IOIO) on the device's CRMX module. |
|
2.
|
Connect the DB-9 connector labeled "P1" (red) to the COM1 or COM2 RS-232 communication port of your computer. |
|
●
|
The RS-232 port is not intended for permanent connection. |
|
●
|
The DB-9 connector labeled "P2" is used only for debugging. |