Connecting to E1/T1 Trunks
The procedure below describes how to connect to E1/T1 trunks.
To protect against electrical shock and fire, use a 26 AWG min wire to connect T1 or E1 ports to the PSTN.
Avertissements: Pour vous protéger contre l’électrocution et le feu, utilisez un fil de 26 AWG au minimum pour connecter le port T1/E1 au PSTN.
The TRUNKS module is a separate orderable item. This section is applicable only if your device is installed with such a module.
Cabling specifications:
| ■ | Cable: 26 AWG min. |
| ■ | Connector: RJ-48c |
| ■ | Connector Pinouts: |
RJ-48c Connector Pinouts for E1/T1
| ➢ | To connect to E1/T1l trunks: |
| 1. | Connect the RJ-48c connector on one end of the E1/T1 trunk cable to the port on the device's TRUNKS module. |
| 2. | Connect the other end of the trunk cable to the PBX/PSTN switch. |