Notice
Information contained in this document is believed to be accurate and reliable at the time of printing. However, due to ongoing product improvements and revisions, AudioCodes cannot guarantee accuracy of printed material after the Date Published nor can it accept responsibility for errors or omissions.
This document is subject to change without notice.
Date Published: November-10-2024
WEEE EU Directive
Pursuant to the WEEE EU Directive, electronic and electrical waste must not be disposed of with unsorted waste. Please contact your local recycling authority for disposal of this product.
Security Vulnerabilities
All security vulnerabilities should be reported to vulnerability@audiocodes.com.
Customer Support
Customer technical support and services are provided by AudioCodes or by an authorized AudioCodes Service Partner. For more information on how to buy technical support for AudioCodes products and for contact information, please visit our website at https://www.audiocodes.com/services-support/maintenance-and-support.
Documentation Feedback
AudioCodes continually strives to produce high quality documentation. If you have any comments (suggestions or errors) regarding this document, please fill out the Documentation Feedback form on our website at https://online.audiocodes.com/documentation-feedback.
Stay in the Loop with AudioCodes
Notes and Warnings
The device is an INDOOR unit and thus, must be installed ONLY indoors. In addition, Ethernet port interface cabling must be routed only indoors and must not exit the building.
Avertissement: L’appareil est une unité d’INTERIEUR et doit donc obligatoirement être installé en intérieur. En outre, le câblage de l’interface du port Ethernet doit être acheminé uniquement en intérieur et ne doit pas sortir du bâtiment.
Installation of this device must be in a weather protected location of maximum ambient temperature of 40°C.
Avertissement: L’installation de cet appareil doit avoir lieu dans un local protégé des intempéries de température ambiante maximale de 40°C.
This device must be installed only in a restricted access location.
Avertissement: L’entretien de maintenance de cet appareil doit être effectué uniquement par un personnel de service qualifié dans des locaux à accès limité et l’appareil étant branché à une prise mise à la masse.
Service of the device must be made only by qualified service personnel.
The device must be connected only to a grounded AC mains power socket.
Caution Electrical Shock
Do not attempt to open or disassemble this device. The device carries high voltage. Contact with internal components may cause electrical shock and bodily harm.
Attention életrocution
Ne tentez pas d’ouvrir ni de démonter l’appareil. L’appareil transporte une haute tension et son contact avec des composants internes risque de vous exposer à l’électrocution et à des lésions corporelles
This device is intended to accommodate only AMC modules approved by AudioCodes.
Avertissement: Cet appareil est destiné à recevoir uniquement des modules AMC approuvés par AudioCodes.
Related Documentation
Document Name |
---|
Document Revision Record
LTRT |
Description |
---|---|
41743 |
Initial document release. |
41745 |
Map of slots on front panel was updated. |
41746 |
Front-panel description regarding slot numbers updated; module slot assignment updated. |
41748 |
Output ratings removed. |
41750 |
DC power added. |
41751 |
AC/DC input ratings updated. |
41752 |
Drawings of MPM8B, MPM12B, OSN modules. |
41753 |
Troubleshooting added. |
41754 |
Logo updated. |
41755 |
Airflow illustration. |
41756 |
19-inch rack mounting brackets updated. |
41758 |
Chassis updated with new logo. |
41759 |
Logo removed from chassis top. |
41770 |
Duration of press for reset to defaults; trademarks. |
41771 |
HDMX module slot assignment updated for hardware configuration "SBC CPU + OSN". |
41772 |
Shipped items updated (rear-mounting brackets) |
41773 |
Min. operating temp. |
41774 |
Reset button press durations. |
41776 |
EN/UL 60950 updated; 19-inch rack updated; shipped items updated. |
41777 |
CPU replacement procedure update and new device replacement procedure. |
41778 |
LEDs for HA state updated |