Ports and Buttons
The device's front panel is shown in the following figure and described in the subsequent table.
Front Panel
Front Panel Description
|
Item # |
Label |
Description |
|---|---|---|
|
1 |
POWER / STATUS |
LEDs indicating the status of the power and reboot/initialization. For more information, see LED Descriptions. |
|
2 |
// |
Reset pinhole button for resetting the device and optionally, for restoring the device to factory defaults. To restore the device to factory defaults, do the following: With a paper clip or any other similar pointed object, press and hold down the pinhole button for at least 12 seconds, but no longer than 25 seconds |
|
3 |
CONSOLE |
RJ-45 port for RS-232 serial communication |
|
4 |
LAN |
Up to four Gigabit Ethernet (10/100/1000Base-T) ports for connecting to LAN network (IP phones, computers, or switches). These ports support half- and full-duplex modes, auto-negotiation, and straight or crossover cable detection. |
|
5 |
PRI |
Single E1/T1 port interface (RJ-48). Note: PRI interface is a customer-ordered item. |
|
6 |
USB |
Two USB 2.0 ports, which can be used, for example, for various storage capabilities using an external USB hard drive or flash disk (disk on key). |