Implement Physical Network Separation using Ethernet Port Groups

For the devices mentioned in the note above, you can physically separate the network traffic by Ethernet ports, using Ethernet Groups. Each Ethernet Group can include up to two physical Ethernet ports. The Ethernet Device defines the VLAN per Ethernet Group. The Ethernet Device is then assigned to the network interface as an Underlying Device. The following procedure provides an example of assigning different ports per traffic type.

➢

To implement physical network separation:

1.

Open the Ethernet Groups table (Setup menu > IP Network tab > Core Entities folder > Ethernet Groups), and then assign ports to different Ethernet Group:

Assigning Ports to Ethernet Groups

2.

Open the Ethernet Devices table (Setup menu > IP Network tab > Core Entities folder > Ethernet Devices), and then configure VLAN IDs per Ethernet Group:

Assigning VLANs to Ethernet Groups

3.

Open the IP Interfaces table (Setup menu > IP Network tab > Core Entities folder > IP Interfaces), and then sssign the Ethernet Devices (VLANs) to the different traffic network interfaces:

Assigning Ethernet Devices (VLANs) to IP Interfaces