advanced
This command configures advanced gateway parameters.
Syntax
(config-voip)# gateway advanced (gw-settings)#
|
Command |
Description |
|---|---|
|
attempted-call-count-on-start {off|on} |
Enables the device to count calls only at call start stage for SNMP performance monitoring MIBs that count attempted calls (IP-to-Tel and Tel-to-IP), for example, acPMSIPAttemptedCallsTable. |
|
enable-rai {off|on} |
Enables generation of an RAI (Resource Available Indication) alarm if the device's busy endpoints exceed a user-defined threshold. |
|
forking-handling {parallel-handling|sequential-handling} |
Defines how the device handles the receipt of multiple SIP 18x forking responses for Tel-to-IP calls. |
|
forking-timeout |
Defines the timeout (in seconds) that is started after the first SIP 2xx response has been received for a User Agent when a Proxy server performs call forking (Proxy server forwards the INVITE to multiple SIP User Agents). |
|
reans-info-enbl {off|on} |
Enables the device to send a SIP INFO message with the On-Hook/Off-Hook parameter when the FXS phone goes on-hook during an ongoing call and then off-hook again, within the user-defined regret timeout. |
|
register-by-served-tg-status |
Defines if the device sends a registration request (SIP REGISTER) to a Serving IP Group (SIP registrar), based on the Trunk Group's status (in-service or out-of-service) for ISDN PRI and CAS. |
|
tel2ip-no-ans-timeout |
Defines the time (in seconds) that the device waits for a 200 OK response from the called party (IP side) after sending an INVITE message, for Tel-to-IP calls. |
|
time-b4-reordr-tn |
Defines the delay interval (in seconds) from when the device receives a SIP BYE message (i.e., remote party terminates call) until the device starts playing a reorder tone to the FXS phone. |
|
use-conn-sdpses-or-media {dont-care|session-only|media-only} |
Defines how the device displays the Connection ("c=") line in the SDP Offer/Answer model. |
Command Mode
Privileged User