debug adsl-connection

This command displays the ADSL line synchronization status (Physical Interface). The output can be displayed in the CLI as well as in the Syslog viewer after Syslog is enabled.

Syntax

# debug adsl-connection

Command Mode

Privileged User

Example

This example displays the ADSL line synchronization status. Note that the debug log command, run first, displays logs. If you run the debug adsl-connection command without running the debug log command, the log messages of the debug adsl-connection command will be sent to a log that can be displayed by running the show log command. If Syslog messaging is configured, the message will be sent to the Syslog server.

# debug log
# debug adsl-connection
 
May 16 20:01:01  DATA: interface adsl 0/2 line State: 0x00000200 (Silent).
May 16 20:01:03  DATA: interface adsl 0/2 line State: 0x00000300 (Handshake).
May 16 20:01:07  DATA: interface adsl 0/2 line State: 0x00000380 (Full Init).
May 16 20:01:32  DATA: interface adsl 0/2 line State: 0x00000801 (Showtime TC Sync).

This example displays the ADSL line synchronization status in the Syslog server:

# enable syslog
# debug adsl-connection