dtmf-and-dialing

Enables automatic muting of DTMF digits when out-of-band DTMF transmission is used.

Configures Unicode-to-ASCII character conversion rules.

Defines the default destination phone number which is used if the received message doesn't contain a called party number and no phone number is configured in the Trunk Group table.

Defines the Dial Plan Index.

Defines the digit map pattern used to reduce the dialing period when ISDN overlap dialing for digital interfaces.

Defines the duration, in seconds, that the dial tone is played, for digital interfaces, to an ISDN terminal.

Defines the threshold of the received DTMF InterDigitTime, in milliseconds.

Defines the first preferred transmit DTMF negotiation method.

Defines the hook-flash transport type.

Defines the duration, in seconds, of the hotline dial tone.

Enables ISDN overlap dialing for IP-to-Tel calls.

Defines the minimum number of overlap digits to collect - for ISDN overlap dialing - before sending the first SIP message for routing Tel-to-IP calls.

Defines the maximum number of collected destination number digits that can be received.

Defines the DTMF Out-of-Band transport method.

Global parameter that enables the device to declare the RFC 2833 'telephony-event' parameter in the SDP.

Defines the second preferred transmit DTMF negotiation method.

Defines the representation for ‘special’ digits‘*’ and ‘#’. that are used for out-of-band DTMF signaling using SIP INFO/NOTIFY.

Determines whether the asterisk*. and pound#. digits can be used in DTMF.

Enables Strict Dial Plan.

Defines the Tx RFC 2833 DTMF relay dynamic payload type for outbound calls.

Note: The location of this command in the CLI is for backward compatibility. The correct location is configure voip > media rtp-rtcp.