Installing the OSN Server Modules
The OSN server is a customer-ordered item. The procedure below describes how to install the OSN server modules (OSN and HDMX) in the chassis.
Power off the device before installing the OSN modules.
Avertissement: Mettez l’appareil hors tension avant d’installer le OSN.
Before installing the OSN server modules, see Module Slot Assignment for module slot assignment.
| ➢ | To install the OSN sever modules: |
| 1. | Disconnect the power cords from the power sources, and then remove the power cords from the power connections on the two Power Supply modules. |
| 2. | Install the OSN Module: |
| a. | Remove the blank AMC-module slot covers from the two slots intended for the OSN server modules, by gently pulling on the handle of the modules until they slide out of the slots completely. |
Extracting Blank AMC Modules from Slots for OSN Server (Top View)
| b. | Hold the OSN module in the correct orientation as shown in the following figure, and then gently insert the module into the upper slot, sliding it along the slot's guide rails until it makes contact with the card-edge connector located on the backplane. |
Inserting OSN Module
| c. | Push the module's handle until it clicks firmly in to engage the module with the slot rails. |
| 3. | Install the HDMX Module: |
| a. | Hold the HDMX module in the correct orientation as shown in the following figure, and then gently insert the module into the upper slot, sliding it along the slot's guide rails until it makes contact with the card-edge connector located on the backplane. |
Inserting HDMX Module
| b. | Push the module's handle until it clicks firmly in to engage the module with the slot rails. |
| 4. | Power up the device. |