Bypass Mechanism for V.34 Fax Transmission

In this proprietary scenario, the device uses bypass (or NSE) mode to transmit V.34 faxes, enabling the full utilization of its speed.

➢

To use bypass mode for T.30 and V.34 faxes:

On the Fax/Modem/CID Settings page, do the following:

●

Set the 'Fax Transport Mode' parameter to Bypass [FaxTransportMode = 2].

●

Set the 'V.22 Modem Transport Type' parameter to Enable Bypass [V22ModemTransportType = 2].

●

Set the 'V.23 Modem Transport Type' parameter to Enable Bypass [V23ModemTransportType = 2].

●

Set the 'V.32 Modem Transport Type' parameter to Enable Bypass [V32ModemTransportType = 2].

●

Set the 'V.34 Modem Transport Type' parameter to Enable Bypass [V34ModemTransportType = 2].

Configure the [V34FaxTransportType] parameter to [2] (Bypass).

➢

To use bypass mode for V.34 faxes, and T.38 for T.30 faxes: