supp-service-settings
This command configures supplementary services.
Syntax
(config-voip)# gateway dtmf-supp-service supp-service-settings (gw-suppl-serv)#
|
Command |
Description |
|---|---|
|
3w-conf-mode |
Defines the mode of operation for three-way conferencing. |
|
3w-conf-nonalloc-prts |
Define the ports that are not affected by three-way conferencing. |
|
aoc-support |
Enables AoC-D and AoC-E from ISDN to SIP. |
|
as-subs-ipgroupid |
IP Group ID for AS subscribe purposes. |
|
blind-transfer |
Keying sequence for performing blind transfer. |
|
call-forward |
Enable Call Forward service. |
|
call-hold-remnd-rng |
Call-hold reminder ring maximum ringing time, in seconds. |
|
call-prio-mode |
Priority mode. |
|
call-waiting |
Enables Call Waiting service. |
|
caller-id-type |
Defines the Caller ID standard. |
|
cfb-code |
Supplementary Service code for activating Call Forward Busy. |
|
cfb-deactivation-code |
Supplementary Service code for deactivating Call Forward Busy. |
|
cfe-ring-tone-id |
Ringtone type for Call forward notification. |
|
cfnr-code |
Supplementary Service code for activating Call Forward No Reply. |
|
cfnr-deactivation-code |
Supplementary Service code for deactivating Call Forward No Reply. |
|
cfu-code |
Supplementary Service code for activating Call Forward Unconditional. |
|
cfu-deactivation-code |
Supplementary Service code for deactivating Call Forward Unconditional. |
|
conf-id |
Identification of conference call used by SIP INVITE. |
|
connected-number-plan |
Enforces Q.931 Connected Number Type. |
|
connected-number-type |
Enforces Q.931 Connected Number Type. |
|
dtmf-during-hold |
Enables playing DTMF to Tel during hold. |
|
enable-3w-conf |
Enables 3-way conferencing feature. |
|
enable-caller-id |
FXS: Generate Caller ID; FXO: Collect Caller ID information. |
|
enable-mwi |
Enables MWI. |
|
enable-transfer |
Enables Call Transfer service. |
|
estb-conf-code |
Control Key activation for 3-way conference. |
|
flash-key-seq-style {flash-hook| sequence-1| sequence-2 | sequence-3} |
Flash key sequence. Note: The parameter is applicable only to FXS interfaces. |
|
flash-key-toggle-to-secondary |
Defines the flash-hook key with digit sequence for toggling from the primary call to the secondary call. Note: The parameter is applicable only to FXS interfaces. |
|
flash-key-toggle-to-primary |
Defines the flash-hook key with digit sequence for toggling from the secondary call to the primary call. Note: The parameter is applicable only to FXS interfaces. |
|
flash-key-call-transfer |
Defines the flash-hook key with digit sequence for initiating a call transfer. Note: The parameter is applicable only to FXS interfaces. |
|
flash-key-conference |
Defines the flash-hook key with digit sequence for initiating a three-way conference call. Note: The parameter is applicable only to FXS interfaces. |
|
flash-key-bye-and-toggle |
Defines the flash-hook key with digit sequence for ending the active call (sends a SIP BYE message) when you have two calls and one is on-hold. When the sequence is pressed, the previously held call becomes the active call. Note: The parameter is applicable only to FXS interfaces. |
|
flash-key-bye-2-secondary |
Defines the flash-hook key with digit sequence for ending the call that is currently on hold (sends a SIP BYE message). Note: The parameter is applicable only to FXS interfaces. |
|
flash-key-seq-tmout |
Flash key sequence timeout. |
|
held-timeout |
Maximum time allowed for call to be retrieved from IP, in seconds. |
|
hold |
Enables Call Hold service. |
|
hold-format |
Call hold format. |
|
hold-to-isdn |
Enables Hold/Retrieve from and to ISDN. |
|
hook-flash-code |
If Rx during session, act as if hook flash Rx from Tel side. |
|
ignore-isdn-subaddress |
Ignores ISDN Subaddress. |
|
isdn-xfer-complete-timeout |
Max time, in seconds, to wait for transfer response from PSTN. |
|
mlpp-diffserv |
DiffServ value for MLPP calls. |
|
music-on-hold |
Enables playing Music On Hold. |
|
mute-dtmf-in-overlap |
In overlap mode if set mute in-band DTMF till destination number is received. |
|
mwi-analog-lamp |
Enables MWI using an analog lamp 110 Volt. |
|
mwi-display |
Enables MWI using Caller ID interface. |
|
mwi-ntf-timeout |
Defines the maximum duration (timeout) that a message waiting indication (MWI) is displayed on endpoint equipment (phones' LED, screen notification or voice tone). |
|
mwi-qsig-party-num |
Party Number from msgCentreId in MWIactivate and MWIdeactivate. |
|
mwi-srvr-ip-addr |
MWI server IP address. |
|
mwi-srvr-transp-type |
MWI server transport type. |
|
mwi-subs-expr-time |
MWI service subscription expiration time, in seconds. |
|
mwi-subs-ipgrpid |
IP Group ID for MWI subscribe purposes. |
|
mwi-subs-rtry-time |
MWI service subscriptions retry time after last subscription failure, in seconds. |
|
mx-3w-conf-onboard |
Max on-board conference calls. |
|
nb-of-cw-ind |
Number of call waiting indications to be played to the user. |
|
nrt-sub-retry-time |
NRT subscribe retry time. |
|
nrt-subscription |
Enable subscription for Call forward ringtone indicator services. |
|
precedence-ringing |
Index of the first Call RB tone in the call-progress tones file. |
|
qsig-calltransfer-reverse-enddesignation |
QSIG Call Transfer Reverse End Designation. |
|
reminder-ring {disable|enable} |
Enables the reminder ring. |
|
send-all-cdrs-on-rtrv |
Send only chosen coder or all supported coders. |
|
should-subscribe |
Related to Subscribe/UnSubscribe buttons. |
|
snd-isdn-ser-aftr-restart |
ISDN SERVICE message is sent after restart. |
|
sttr-tone-duration |
Time for playing confirmation tone before normal dial tone is played (msec). |
|
subscribe-to-mwi |
Enable subscription for MWI service. |
|
subscribe-to-ua-profile {disable|enable} |
Enables subscription to UA-Profile events (services), by sending SIP SUBSCRIBE requests. |
|
time-b4-cw-ind |
Time before call waiting indication is sent to a busy line, in seconds. |
|
time-between-cw |
Time between one call waiting indication to the next, in seconds. |
|
transfer-prefix |
Prefix added to the called number of a transferred call. |
|
ua-profile-srvr-ip-addr |
Defines the address (IP address or domain name) of the UA-Profile server. |
|
ua-profile-srvr-transp-type {not-configured|udp|tcp|tls} |
Defines the transport protocol for sending SIP SUBSCRIBE requests to the UA-Profile server. |
|
ua-profile-subs-expr-time |
Defines the UA-Profile service subscription expiration time (in seconds). |
|
ua-profile-subs-ipgroupid |
Defines the UA-Profile server as an IP Group (configured in the IP Groups table). |
|
waiting-beep-dur |
Call Waiting tone beep length (msec). |
Command Mode
Privileged User
Example
This example enables the reminder ring feature:
(config-voip)# gateway dtmf-supp-service supp-service-settings (gw-suppl-serv)# reminder-ring enable (gw-suppl-serv)# reminder-ring enable