multilink bundle-id (MLP over T1)
This command associates the current MLP serial interface to a virtual bundle id. Setting more than one serial interface to the same bundle id bonds both interfaces under the same virtual bundle.
You can configure an identical virtual bundle for the MLP over T1 serial WAN interface and the Multilink WAN interface, where <bundle-id> is specified for both interfaces. In the example below, <bundle-id> is specified as ‘8’.
Syntax
multilink bundle-id <id>
|
Command |
Description |
|---|---|
|
<id> |
Defines the bundle-id (0-255). |
Default
No default value exists; you must specify a bundle id.
Command Mode
Privileged User
Example
This example associates a MLP serial interface 0/1 to logical bundle 0:
(conf-if-serial-mlp 0/1)#multilink bundle-id 8